To add lines (for On Line cuts or for guides), export the single solid body as you usually would, then activate the advanced button and export the sketch containing the lines. The default 'single solid body' export mode analyzes solid shapes. If that does not solve the problem, then you can open the SVG in a 2d vector editing package (such as Illustrator or Inkscape) and enlarge the pocket until it is large enough to accommodate the cutter you wish to use. You can change your cutter to a smaller diameter on-tool or you can change the cut type from a pocket cut to an inside cut

If a ledge is narrower than the cutter installed, then the pocketing protective boundary tool paths will not be produced. Shoulders and narrow ledges don't produce tool paths on Origin: The Shaper logo will display in the top tool bar (see below).

If the plugin fails to install, follow these steps:ġ: Uninstall Fusion 360 if it was downloaded from the Apple StoreĢ: Reset Apple home permissions following the instructions found hereģ: Download and install Fusion 360 from the Autodesk web site hereĤ: Download and install the Shaper Add-In from the Autodesk app store hereĥ: Go to Modeling mode in Fusion 360.

Autodesk fusion 360 mac